Yorkville Sound

YSM2P-II Active Monitor (Single)

SKU: # 324913   |   Model: # YSM2P-2   |    Product Reviews0 Reviews  Write a Review

YSM2P-II Active Monitor (Single)
 This product is no longer available.
YSM2P - Powered Monitor - 46w, 5.25 inch / 1 inch

The YSM2P powered speaker enclosure system is an advanced studio monitor. It is equally at home in a professional recording studio, project studio, or even a living room. Development of the renowned YSM1P has helped us provide the YSM2P with functionality and user-friendliness at a truly reasonable cost. Components include a 1-inch domed tweeter and a 5 1/4-inch woofer. The woofer is a low-resonance 4-ohm driver fabricated with a woven laminate cone (which helps promote use of the full 32 watts of power from the YSM2Ps internal LF amplifier). The HF side of amplifier is capable of delivering up to 14 watts to the 1-inch, high-performance tweeter. Optimal performance is also achieved by use of an active crossover specifically developed for the YSM2P. The YSM2P also features an input trim control for precision tweaking according to room acoustics.
A smooth frequency response gives the YSM2P ample source representation without equalization. A precisely tuned active crossover enables each driver to take advantage of the bi-amplification. -inch or XLR input jacks allow for maximum versatility.

The input, located at the rear of the enclosure, accepts line-level signal only (not speaker level). It is ideal to use balanced, shielded cables with a -inch (TRS) or XLR connector however unbalanced 1/4-inch jacks can also be used. Each YSM2P should be connected to a single line-level source (e.g., the Right or Left line output from a mixer or preamp). If you want to use multiple YSM2Ps, they can be interconnected using "Y" adaptors.

The Input Trim control allows you to adjust the volume of each monitor until the desired sound level and Left/Right (or Front/Rear) balance is achieved. If clipping distortion becomes audible, reduce the Input Trim level. If more signal reduction is needed, lower your line level from the source with the mixers master level controls.

Shielded drivers ensure the YSM2Ps can be located close to computer and video monitors or hard drive recording systems.

The YSM2P uses a bi-amplification system with separate power amps for the tweeter and the woofer The YSM2P utilizes an electronically active crossover network tuned specifically for each driver. This type of crossover network divides the signal much more precisely than traditional passive crossover networks.

Features
Bookmatched Left/Right pairs
Bi-amplified operation features 32-watts of low frequency power and 14-watts for the high frequency
Components include a 1-inch domed tweeter and a woven laminate cone 5 1/4-inch woofer
Precisely tuned active crossover enables each driver to take advantage of the bi-amplification
1/4-inch TRS or XLR input jacks
Input Trim control allows you to adjust the volume of each monitor
Power switch is located at the rear of the enclosure

Q & A


There are currently no questions for this product.

Reviews


There are currently no reviews for this product. Be the first to write one!

Rental rates


This product is normally available for rental. Please contact your preferred location for further information.

1 Day from $3.00

1 Week $6.00

1 Month $12.00

Performance Warranty Banner

Protect your investment with the Long & McQuade Performance Warranty

A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.

Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.

How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
  • Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
  • Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
  • No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
  • Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
  • Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
  • Loaners Available: A loaner product may be given while the product is being repaired.
  • Power Surge Protection: Your product is covered even if damaged from a power surge.
  • Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
  • Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
 

Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.

Purchasing additional years of coverage

Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.

If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:

  • NEW products: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
  • USED products: 4% of the current new selling price to increase the warranty from 3 months to 1 year. 4% for each additional year.
  • GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
  • BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.