sE Electronics RNT Rupert Neve Tube Condenser Microphone
Additional Photos:
Product Videos :
The RNT utilizes fully discrete, Class-A electronics throughout both of its active stages. The first stage is tube-based, with a hand-selected, low-noise ECC82 tube within the microphone chassis, and implementing a custom-built Rupert Neve Designs output transformer.
The second stage is within the floor box which controls polar pattern, filter and gain switching and is also coupled with a second custom-made Rupert Neve Designs output transformer. This second stage is is built around the same custom op-amps used in Rupert Neve Designs' flagship 5088 recording console, known worldwide for its unrivaled transparency and headroom.
The custom handcrafted large-diaphragm true condenser capsule is the finest capsule sE has ever made, born from years of rigorous testing and listening, and developed and constructed by hand in sE's own factory.
The Class-A electronics and switchable gain ensure a massive dynamic range, with high sound pressure level (SPL) handling capability and extremely low-noise components, and the switchable low-cut filters eliminate rumble or footfall noise, and can also compensate for an excess of bass frequencies caused by the proximity effect. This enables the RNT to close-mic many instruments including electric guitar speaker cabinets, brass instruments and drums.
Lastly, the 9-position polar pattern switch allows for omnidirectional, cardioid, and figure-eight pickup patterns (plus several positions in between each) for precise tailoring of the balance between direct and ambient sound when recording with the RNT.
In the Box:
- RNT microphone
- Custom shock-mount
- RNT Floor Box (Power Supply)
- 8-pin cable (to connect mic to floor box)
- IEC power cable
- Wooden microphone box
- Flight case
- sE logo sticker
- User manual with warranty card
Specifications
Capsule: Handcrafted 1" diaphragm true condenser
Tube Complement: 1x 12AU7/ECC82
Polar Patterns: 9 (omni, cardioid, figure-8, plus 3 steps between each)
Frequency range: 20 Hz - 20,000 Hz
Sensitivity: 16 mV/Pa (-36 dB)
Gain: -12 / 0 / +12 dB, switchable
Max SPL: 151 dB
Equivalent Noise Level: 18 dB(A)
Dynamic Range: 133 dB
Signal to Noise Ratio: 76 dB
Low Cut Filter: 40 / 80 Hz, 12 dB/oct, switchable
Electrical Impedance: 30 Ohms
Recommended Load Impedance: >2k Ohms
Connectivity: 3-pin male XLR connector (floor box)
Microphone Dimensions: Diameter: 62 mm (2.44 in.), Length: 240 mm (9.45 in.)
Microphone Weight: 989 g (34.90 oz.)
Floor Box Dimensions: 356 x 135 x 100 mm (14.02 x 5.31 x 3.94 in.)
Floor Box Weight: 3.91 kg (137.79 oz.)
Media
Q & A
Reviews
Protect your investment with the Long & McQuade Performance Warranty
A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.
Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.
How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
- Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
- Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
- No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
- Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
- Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
- Loaners Available: A loaner product may be given while the product is being repaired.
- Power Surge Protection: Your product is covered even if damaged from a power surge.
- Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
- Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.
Purchasing additional years of coverage
Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.
If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:
- NEW products: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
- USED products: 4% of the current new selling price to increase the warranty from 3 months to 1 year. 4% for each additional year.
- GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
- BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.