Lectrosonics
L-Series LR Hybrid Portable Wireless Receiver (A1: 470.100 to 537.575 MHz)
Additional Photos:
The receiver is powered by internal AA batteries or with an optional battery eliminator. The top panel includes an IR port for transmitter setup. Firmware updates are enabled via a USB port on the side panel. The housing is made from a solid machined aluminum billet, and the LR is built with detachable antennas that allow for remote antenna mounting.
The Lectrosonics LR Receiver is available in three operating frequencies.
Main Features:
• Tunes over a 75 MHz range*
• Tracking front-end filters
• Digital Hybrid Wireless with compatibility modes for use with earlier transmitters
• Compact size powered by two AA batteries or an optional battery eliminator
• LCD with RF spectrum scanning
• SmartSquelchTM noiseless muting adapts automatically for near/far operation
• DSP-based pilot tone for squelch control
• USB port for firmware updates
• IR sync port for transmitter setup
Lectrosonics LR Specifications:
Available in three Operating Frequencies:
• Tuning range A1: 470.100 - 537.575 MHz
• Tuning range B1: 537.600 - 614.375 MHz
• Tuning range C1: 614.400 - 691.175 MHz
Frequency selection steps: Selectable; 100 kHz or 25 kHz
Receiver Type: Dual conversion, superheterodyne
IF Frequencies: 243.950 MHz and 250.000 kHz
Frequency stability: +/-0.001 %
Front end bandwidth: 20 MHz @ -3 dB
Sensitivity
• 20 dB SINAD: 1.0 uV (-107 dBm), A weighted
• 60 dB Quieting: 2.2 uV (-100 dBm), A weighted
Squelch quieting: Greater than 100 dB typical
Modulation acceptance: +/-100 kHz max.; varies with selected compatibility mode
Image and spurious rejection: 85 dB
Third order intercept: 0 dBm
Diversity method: SmartDiversityTM phased antenna combining
FM detector: Digital Pulse Counting Detector
RF spectrum analyzer: Single and multiple block scanning modes; coarse and fine views of results
Antenna inputs: 50 Ohm; SMA female connectors
Audio output: TA3 male (mini XLR) balanced output
Audio output level: Adjustable -50 to +5 dBu in 1 dB steps; unbalanced output level is 6 dB lower
Front panel controls and indicators:
• Sealed panel with membrane switches
• LCD for setup menus and monitoring
Audio test tone: 1 kHz, -50 dBu to +5 dBu output (bal); 1% THD
Transmitter battery type selection: AA alkaline or lithium
Audio polarity selection: Normal or inverted
Compatibility modes:
• Digital Hybrid (North American and European)
• Lectrosonics 100, 200 and 300 Series
• Lectrosonics IFB
• Non-Lectrosonics modes 3, 6 and 7 (contact the factory for details)
SmartNR (noise reduction): OFF, NORMAL, FULL modes (available in Digital Hybrid mode only)
Audio Performance Frequency Response: 32 Hz to 20 kHz (+/- 1 dB) receiver only (see transmitter documentation for overall system response)
Total harmonic distortion: < 0.4 (0.2% typical in Digital Hybrid mode)
Top panel features:
• TA3M audio output jack;
• (2) SMA antenna jacks
• IR (infrared) port
Operating runtimes: 4 hours, AA alkaline
Operating temperature: -20 C to +50 C
Weight: 185.4 grams (6.54 ozs.) with two AA lithium batteries
Dimensions (housing): 3.21 x 2.45 x .84 in. (82 x 62 x 21 mm)
Q & A
Reviews
Protect your investment with the Long & McQuade Performance Warranty
A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.
Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.
How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
- Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
- Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
- No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
- Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
- Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
- Loaners Available: A loaner product may be given while the product is being repaired.
- Power Surge Protection: Your product is covered even if damaged from a power surge.
- Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
- Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.
Purchasing additional years of coverage
Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.
If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:
- NEW products: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
- USED products: 4% of the current new selling price to increase the warranty from 3 months to 1 year. 4% for each additional year.
- GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
- BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
Great Additions
Reserve in Store
| Product | SKU | Qty |
|---|---|---|
| L-Series LR Hybrid Portable Wireless Receiver (A1: 470.100 to 537.575 MHz) | 699454 |
