ART Pro Audio

Active DI

SKU: # 345781   |   Model: # DUALXDIRECT   |    Product Reviews0 Reviews  Write a Review

Active DI

Additional Photos:

Active DI

Buy Online

 Add to Cart

Buy In-Store

The DUALXDirect provides two independent high quality active interfaces that let you connect instrument, line, or speaker level signals to a mixer or other balanced inputs. Each of the high impedance 1/4" and XLR inputs (provided via "combo" jacks) are buffered and converted by very low noise active electronics into an isolated, balanced, low impedance signal output. The DUALXDirect has an extremely flat and wide frequency response and can handle high signal levels. This gives the DUALXDirect a very clean and neutral sound with a wide variety of signal sources and over long signal runs in high noise environments.

The input ATTENUATOR switches allow for a wide range of signal levels and the input THRU jacks allow for tapping off of your signal chain. The GROUND LIFT switches let you totally separate the input and output signal grounds, when appropriate, to isolate two systems, thereby reducing hum and ground-loop noise.

The DUALXDirect''s active circuitry is powered by phantom voltage from the OUTPUT connections or by an internal 9V battery, when external power is not available. When powered by a battery, it draws less than 7.5 mA which should provide more than 100 hours of operation with a new battery (alkaline recommended). If phantom power is available, then the DUALXDirect will automatically draw its power from the external source. The POWER ON/OFF switch lights more dimly when the unit is running off of the battery, lights more brightly when it is running off of phantom power, and is off when the unit is inactive.

The compact black-anodized all aluminum case and it's active design allow the DUALXDirect to provide years of trouble free service in Live Sound, Permanent/Fixed Install, D.J., and virtually any PA application. It's full feature set, rugged construction, and high-end specifications make the DUALXDirect the obvious choice.

FEATURES:
• Fully active design
• Phantom voltage or 9V battery powered
• Converts high-impedance balanced / unbalanced inputs into 600 Ohm balanced outputs
• Switchable input attenuation (0, -30 dB)
• Switchable ground lift
• 1/4" TRS / XLR combo connector inputs
• XLR connectors for balanced outputs
• Rugged extruded aluminum case

SPECIFICATIONS:
• Frequency Response: 10 Hz - 100 kHz, 0.5 dB @ +0 dBu
• THD: <.05% (typical)
• Dynamic Range: >100 dB (typical)
• Channel Separation: > 80 dB (typical)
• Maximum Input Level: +4, +34 dBu
• Maximum Output Level: +6 dBu (battery powered), +14 dBu (phantom powered)
• Input Connections: 1/4" TRS | XLR female balanced / unbalanced (2), 470k Ohm
• Thru Connections: 1/4" TRS (2)
• Output Connections: XLR male balanced (2), <600 Ohm
• Input Attenuation: Switchable, (0, -30 dB)
• Power Requirements: 9V @ 7.5 mA (battery, alkaline recommended), 18 - 48V DC @ 6.4 mA (phantom power per channel)
• Dimensions (DWH inches): 3.9 x 4.6 x 1.85
• Dimensions (DWH mm): 99 x 117 x 47
• Weight: 0.84 lbs / 0.38 kg

Q & A


There are currently no questions for this product.

Reviews


There are currently no reviews for this product. Be the first to write one!

Performance Warranty Banner

Protect your investment with the Long & McQuade Performance Warranty

A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.

Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.

How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
  • Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
  • Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
  • No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
  • Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
  • Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
  • Loaners Available: A loaner product may be given while the product is being repaired.
  • Power Surge Protection: Your product is covered even if damaged from a power surge.
  • Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
  • Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
 

Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.

Purchasing additional years of coverage

Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.

If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:

  • NEW products: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
  • USED products: 4% of the current new selling price to increase the warranty from 3 months to 1 year. 4% for each additional year.
  • GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
  • BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.