DiMarzio 250K Custom Taper Pot for Volume 250K Custom Taper Pot for Volume

Standard guitar pots limit your musical expression, only starting to deliver sound at about "3" on the dial and then never getting much louder above "7". DiMarzio's custom taper pot is made to solve that problem, by precisely delivering the same ratio of signal-to-turn as an actual 10-position actuator. This provides players with audiophile-like control over dramatic volume swells and signal gain, so you can truly use the guitar's total range. And don't worry about wearing these out - each pot is rated to 10,000 cycles at 2,000 cycles per hour.

Features
• Pre-wired with a "high-pass" filter (also known as a treble bleed circuit)
• Machined brass split shaft and bushings
• 24 teeth and 32-thread turn, a perfect fit for US knobs, including DiMarzio, Fender® and Gibson®
• Direct replacement for standard 3/8-inch (9.525mm) holes found on most Fenders and Gibsons