Departments > Pro Audio & Recording > Power Amps & Crossovers > Outboard - Power Amplifiers > Ashly Audio > TRA-4150 4-Channel 80W Power Amplifier with 70V/100V Transformer

Ashly Audio

TRA-4150 4-Channel 80W Power Amplifier with 70V/100V Transformer

SKU: # 485802   |   Model: # TRA-4150   |    Product Reviews0 Reviews  Write a Review

TRA-4150 4-Channel 80W Power Amplifier with 70V/100V Transformer

Additional Photos:

TRA-4150 4-Channel 80W Power Amplifier with 70V/100V Transformer

Buy Online

The TRA Series amplifiers utilize Ashley Audio's advanced, efficient amplifiers - perfect for low impedance and transformer isolated 25V, 70V or 100V installations with modest power requirements.

All TRA audio controls are on the rear panel. A 6-step LED meter for each channel lets you monitor all levels. TRA amplifiers can drive 4 or 8 Ohm loads and 25V or 70V and 100V
constant voltage lines simultaneously. Output transformers are internally mounted.

This 150W models is also capable of driving 25V constant voltage lines using the direct coupled 4 Ohm output. TRA Series amplifiers incorporate a switch-mode power supply and Class-D amplifier circuitry, providing an extremely power-efficient solution.

All TRA Series amplifiers are convection-cooled, so there's little maintenance after the installation, and no annoying fan noise. Of course you get the reliability, superior sonic quality and rugged construction you've come to expect from Ashly.

TRA Features:

• Convection cooling
• Extremely low noise
• Internally mounted constant voltage transformers
• Extensive protection circuitry
• 6-Step signal level and clip LEDs
• Level attenuators for each channel
• Euroblock inputs/outputs
• Selectable input sensitivity (voltage gain)
• Remote stand-by control
• Adjustable turn-on delay up to eight seconds
• Safety/Compliance: cTUVus, CE, FCC, RoHS

Power Rating: Stereo @ 8 Ohms: 4 x 80W per Channel
Stereo @ 4 Ohms: 4 x 150W per Channel
Stereo @ 70V: 4 x 150W per Channel
Stereo @ 100V: 4 x 150W per Channel
Damping Factor: > 200, 8-Ohm load, < 1kHz
Input Sensitivity: 1.5V
Input Impedance: 20 kOhms, Balanced
Gain: Selectable 26dB or 36dB
Frequency Response: 20 Hz - 20 kHz, +/-1.0dB
Signal-to-Noise Ratio: > 105dB, 20Hz - 20kHz unweighted
Total Harmonic Distortion (THD): < 0.01% (8-Ohm load, 10dB below rated power, 20Hz - 10kHz
Input Connections: 4 x Ch.1,2,3,4 3- Pin Euroblock
Output Connectors: 4 x Ch.1,2,3,4 Screw Terminals
Controls Front Panel: 1 x Power Switch
Controls (Rear):
4 x Gain Control Knobs
4 x Delay DIP Switches
4 x 80Hz HPF On/Off Buttons
4 x Gain Sensitivity Buttons
Indicators:
1 x Blue Power On LED
1 x Yellow Standby LED
1 x Red Protect LED
4 x Red Clip LED's
12 x Green -24/-18/-12dB Signal LED's
8 x Yellow -6/-3dB Signal LED's
Cooling: Convection-cooled
Power Consumption: 75W (1/8 Power Pink Noise @ 4 Ohm)
Typical Current:
Idle: 0.62A
1/8 Power: 1.98A
Dimensions: 483 x 89 x 279.4mm (19 x 3.5 x 11")
Weight: 13.4 kg (29.5 lb)

Q & A


There are currently no questions for this product.

Reviews


There are currently no reviews for this product. Be the first to write one!

Performance Warranty Banner

Protect your investment with the Long & McQuade Performance Warranty

A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.

Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.

How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
  • Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
  • Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
  • No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
  • Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
  • Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
  • Loaners Available: A loaner product may be given while the product is being repaired.
  • Power Surge Protection: Your product is covered even if damaged from a power surge.
  • Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
  • Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
 

Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.

Purchasing additional years of coverage

Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.

If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:

  • NEW products: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
  • USED products: 4% of the current new selling price to increase the warranty from 3 months to 1 year. 4% for each additional year.
  • GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
  • BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.

Great Additions