IK Multimedia

iRig Acoustic Stage is a compact acoustic microphone and advanced digital preamplifier and processing unit that recreates a studio microphone set-up, providing you with all of the true character and tonal nuance of your acoustic in live playing situations. Simply clip the iRig Acoustic Stage's microphone to the sound hole, attach it to the iRig Acoustic Stage pre-amplifier processor, then connect the preamp to your amplifier or mixer. iRig Acoustic Stage also features a Cancel Feedback button that gets rids of annoying frequency feedback during performance.

If you currently perform with an acoustic-electric, iRig Acoustic Stage can greatly enhance your guitars live tone. iRig Acoustic Stage features an AUX input with a blend control that lets you blend your guitars current pickup system with iRig Acoustic Stage giving you even greater tonal flexibility and a roundness to your sound like youve never heard before.

Features
• Advanced MEMS microphone clips on to sound hole
• Preamp/DSP unit
• Dramatically improves your live acoustic sound
• 1/4" AUX input with volume for piezo, magnetic pickups or other onboard electronics
• 1/4" Output with level control for amplifier or PA system
• USB audio out for recording on a computer or mobile device
• Cancel Feedback with multiple frequency feedback cancelling
• 6 tone presets
• Personal instrument calibration
• Works on any acoustic, acoustic electric or ukulele with round sound hole
• Phase switch for optimizing dual source sound

Specifications
Dedicated iRig Acoustic Microphone:
• Microphone Type: MEMS
• Polar Pattern: omnidirectional
• Frequency Response: 30 Hz - 20 kHz, +/-3dB
• Max SPL: 130dB SPL
• Signal-to-Noise Ratio: 101 dBA
• Maximum soundboard thickness: 4mm / 0.16"
Connections:
• Dedicated iRig Acoustic Microphone Input: 2.5mm / 3/32" TS mono jack
• AUX Instrument Input Connector: 6.3mm / 1/4" TS mono jack
• AUX Instrument Input Impedance: 11 kOhms (active instruments only)
• Analog Output Connector : 6.3mm / 1/4" TS mono jack, line-level, low impedance
• Analog Output Impedance: 50 Ohms (can drive long cables without any loss)
• Digital Output Connector: micro-USB
DSP/Interface:
• AD and DA Resolution: 32-bit
• Sampling Rate: 48 kHz
• Interface Output: USB class compliant audio output via micro-USB port
• Power: battery power (2xAA), USB bus power
• Battery Life: approximately 12 hours of continuous usage with alkaline batteries and 15 hours with rechargeable high quality Ni-MH AA cells (2000 mAh and up)

Compatibility
• iRig Acoustic Stage can be connected to any amplifier, mixer or PA system using a 6.3mm / 1/4" TS mono jack cable.