Gear Hunter / M-Audio - PULSARII

Sorry, this item is not available for purchase
Pick up at the store only
Contact Mississauga Ontario
SKU: 290825
Serial: 9020341
Quantity Available: 1
Condition: Used

Phone: (905) 273-3939

Carefully selected for their nearly identical response, matched pairs of Pulsar II microphones from M-Audio deliver superior stereo performance. The brass bodies are equipped with internal shockmounts and low-noise transformerless electronics. Each microphone offers a switchable 10 dB attenuation pad, plus an 80 Hz low-cut filter. Together, these functions allow the Pulsar II microphones to adapt to a variety of applications. The included hardware package allows Pulsar II microphones to be mounted in either an X-Y or ORTF (110) stereo configuration. While ideal for stereo use, these microphones can also be used independently in a wide range of critical recording situations. This complete package includes a stereo mounting bar, hard mounts, risers, windscreens, and cloth bags, as well as a handsome and functional wooden storage/travel case.


*Two response-matched M-Audio Pulsar II microphones
*0.75" diameter, 6-micron sputtered gold diaphragms
*Cardioid pickup patterns
*Class A FET transformerless electronics
*Brass bodies with internal shockmounts
*Switchable 10 dB pads and 80 Hz filters (18 dB/octave)
*48 Volt phantom power required
*Includes stereo bar, hard mounts, risers, wind screens, and soft bagsall in a wooden travel case


Type: Large diaphragm condenser, gold evaporated
Polar pattern: Cardioid
Frequency response: 20 Hz-20 kHz
Sensitivity: 13.8 mV/Pa (-37dBV)
Max.SPL (<0.5% Threshold Level): 134dB; 144 dB using -10 dB Pad
Equivalent noise level: 15dBA weighted
Output impedance: 300-600 Ω
Suggested Mic Pre Input Impedance: 1 - 2.5k Ω
Preamp topology: Class A FET, transformerless
Power requirement: 30 VDC - 50 VDC phantom power
Connector: 3-pin male XLR
Dimensions: 22mm (0.87") diameter x 132mm (5.20") length
Weight:115 g (4.0 oz.)