Gear Hunter

AVANTONE BLACK LION MODDED CV12

Description

The CV-12 is one of the most "bang-for-your-buck" microphones in existence, and has been used to record countless projects from big to small. After gaining much success as a vocal mic, Avantone decided it's time to expand its coverage in the studio and on stage and they have teamed up with Black Lion Audio in Chicago to offer exactly that,

Black Lion Audio has spent over a decade perfecting the art of modding gear. With a flatter response and more headroom than before, the CV-12BLA takes what you love about the CV-12 even further. Mic up drums or piano, close mic a guitar or vocals for a finish so polished it'll put more expensive mics to shame!

This partnership resulted in a meticulous look at every component of the classic CV-12. First and foremost, the circuit has been modified to have the high-mid bump that the CV12 is known for, tamed. A new capsule was used to smooth the highs and bring out the lows resulting in more balance. This flatter response, coupled with higher headroom allows the microphone to be more of a utilitarian microphone that sounds great on just about everything. Full range sources is where the CV-12BLA really shines.

The coupling capacitor is an industry favorite Solen FastCap, which was chosen for its transparency. The 32mm K67 capsule was replaced with a 34mm CK12 styled capsule which was chosen to compliment the new circuit. Leaving no stone unturned, the CV-12BLA features a completely redesigned power supply, featuring a new low-noise circuit.

The CV-12BLA also includes the new Jetsun shock mount. This helps isolate the microphone from the stand while the front section is left open, allowing instruments and windscreens to get several inches closer to the headshell. This design feature allows artists to take advantage of an increased proximity effect, something much more difficult to do with a fully round shock mount.

Details

* Type: Tube-Type True Condenser Microphone
* Capsule: 34mm CK12 styled capsule
* Polar Patterns: 9 patterns selectable at PS-12 power supply
* Frequency Response: 20Hz - 20kHz +/- 3dB
* Output Impedance: less than 50 Ohms / transformer isolated
* Maximum SPL: 136dB (0.5% THD @1000Hz) 146dB with pad engaged
* Equivalent noise level: less than 17dB
* S/N Ratio: 78dB
* Sensitivity: -35dB
* Output Connector: Male XLR 7 pin w/ special power supply & cables
* Tube Type: 6072A
* High-Pass Switch: 80 Hz 6dB/octave Switch
* Attenuation Switch: -10dB Switch
* Power Requirements: Power supply with low-noise circuit
* Finish: Polished Nickel trim / Metallic Cabernet Red Body
* Weight: .8 kgs / 1.8 lbs
* Dimensions: 237mm x 46mm / 9.5" x 1.8"
* Cases included: Velvet-on-foam-lined wooden presentation mic case and rugged carrying case