Radial

Space Heater 500 Series Tube Drive Circuit

SKU: # 444633   |   Model: # R700 0152   |    Product Reviews0 Reviews  Write a Review

Space Heater 500 Series Tube Drive Circuit

Additional Photos:

Space Heater 500 Series Tube Drive Circuit
Space Heater 500 Series Tube Drive Circuit
Space Heater 500 Series Tube Drive Circuit
 This product is no longer available.
Key Features:

• Studio grade 12AX7 tube overdrive
• 35, 70 & 140 volt Heat switch to set plate B+ voltage
• Transformer coupled output for vintage tone
• Variable HPF & LPF filters to focus distortion

The Radial Space Heater 500 is a studio-grade tube distortion for the 500 series format. Built to provide anything from subtle warmth to thick and heavy harmonic distortion, the Space Heater 500 is both useful and fun!

Designed for use in the Radial Workhorse or any other 500 series rack, the Space Heater is built around a 12AX7 tube. First, a drive control lets you determine the amount of signal passing through the tube. Next, a 3-position heat switch allows you to apply 35, 70 or 140 volts at the plate to change how the tube reacts to the signal. At the low 35V setting the tube is starved for voltage which causes the tube to break up at a very low volume. The middle 70V setting is a great starting point and allows the tube to handle more level before breaking up to a moderate distortion. At 140 volts, maximum voltage is applied to the tube producing slight saturation and warmth. Sweepable high-pass and low-pass filters can be assigned 'pre or post' tube, allowing you to focus the tube effect on a particular frequency band or cause the tube to react in a different way. Finally, an output level control provides attenuation or boost through an oversized Jensen transformer specially selected for its big bottom end and vintage character.

Enhancing a snare with a touch of distortion can increase presence without losing dynamic range. Blending in some overdrive to a bass track can add clarity without overpowering. Adding distortion to a vocal track can add character and sizzle to cut through the mix without over-compression. The Space Heater 500's amazing 'adjustability' allows it to be used as a subtle effect or as a high gain monster. And no matter your approach, it is sure to find its way on nearly everything you record!

Applications:

DI Bass recording
Adding some distortion to a direct bass recording can make it sound like an amp in the mix. Experiment with the level and drive controls to take a clean bass into SVT territory!

Harmonic distortion while tracking
Placing the Space Heater in line with your mic preamp allows you to record the luscious harmonic distortion while tracking. Add it to the channel strip of your choice to expand the sonic possiblities.

Apply analog distortion to digital effects
Adding distortion to the output of a digital delay or reverb can mimic your favourite vintage analog effects. Don't be afraid to turn it up! Distortion can differentiate the effected sound from the direct, allowing it to really jump out of the mix!

Q & A


There are currently no questions for this product.

Reviews


There are currently no reviews for this product. Be the first to write one!

Performance Warranty Banner

Protect your investment with the Long & McQuade Performance Warranty

A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.

Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.

How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
  • Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
  • Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
  • No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
  • Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
  • Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
  • Loaners Available: A loaner product may be given while the product is being repaired.
  • Power Surge Protection: Your product is covered even if damaged from a power surge.
  • Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
  • Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
 

Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.

Purchasing additional years of coverage

Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.

If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:

  • NEW products: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
  • USED products: 4% of the current new selling price to increase the warranty from 3 months to 1 year. 4% for each additional year.
  • GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
  • BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.